Trigger Switch Assembly

$6.95

27This item is a re-engineered switch assembly. The actuation is very soft and quiet. While it should work with all varieties of the Midway trigger-sticks (TRON, Satan's Hollow, GORF, etc) it was designed for the replacement handles (TRON, Satan's Hollow) offered by this store.
 

 


Installation is simple:

 

 

  1. Find the two pegs behind the trigger on the half of the shell containing the brass insert.
  2. Place the included spacer over the bottom peg.
  3. Be sure that the open hole on both the switch and mounting plate are aligned and carefully position onto the two pegs as shown in the photo above. Excessive force is not necessary, but it should fit snugly. Push down until lower portion of switch plate is seated on the spacer and the upper portion is mostly on the same plane as the lower portion.
  4. Insert the trigger and make sure the back is aligned with the blade actuator of the switch. Be sure the trigger moves freely and that it actuates the switch when pressed.
  5. Carefully re-assemble.

 


Add to Cart:

  • Model: TSSWITCH01
  • Shipping Weight: 0.1lbs
  • 22 Units in Stock
  • Manufactured by: IDVT Inc.

Please Choose:




This product was added to our catalog on Sunday 30 November, 2008.

Your IP Address is: 3.235.75.229
Copyright © 2024 GroovyGameGear.com.
/*